in force 2026-07-01
02019R1009-20251230 → 02019R1009-20260701
Amended by Regulation (EU) 2025/1421 32025R1421
Commission Delegated Regulation (EU) 2025/1421 of 17 July 2025 amending Regulation (EU) 2019/1009 of the European Parliament and of the Council as regards the conformity assessment procedures for EU fertilising products
detected 2026-09-04
1 provision touched — 1 substantive, 0 date-only, 0 disputed · every change carries an explanation that passed its citation check
MODIFIED +173 −0 Annex IV ANNEX IV§
applies from: unchanged
A new sentence has been added in Module A1, point 4, requiring that the thermal cycles and tests referred to in points 4.3 and 4.4 be carried out in laboratories accredited for those activities by a national accreditation body.
The rest of the visible text of the Annex, including Parts I and II up to and beyond Module A1, is unchanged between the two versions.
Both texts are truncated before their end, so no difference beyond the shown portion can be described.
Cited: Annex IV, v2 · Annex IV, v1
text before / after
02019R1009-20251230 → 02019R1009-20260701
ANNEX IV Conformity assessment procedures PART I APPLICABILITY OF CONFORMITY ASSESSMENT PROCEDURES This Part sets out the applicability of conformity assessment procedure modules, as specified in Part II of this Annex, to EU fertilising products depending on their CMCs as specified in Annex II, … 1,722 unchanged words … PFC 1(C)(I)(a)(i-ii)(A) in Annex I, and (b) the detonation resistance requirement referred to in point 5 under PFC 1(C)(I)(a)(i-ii)(A) in Annex I. The thermal cycles and tests shall be carried out under the responsibility of a notified body chosen by the manufacturer. The thermal cycles and test referred to in points 4.3 and 4.4 shall be carried out in laboratories that are accredited for those activities by a national accreditation body. 4.1. Thermal cycles prior to a test for compliance with the oil retention requirement referred to in point 4 under PFC 1(C)(I)(a)(i-ii)(A) in Annex I 4.1.1. Principle and definition In a closed suitable laboratory flask, heat the sample from ambient temperature to … 9,116 unchanged words … manufacturer’s obligations set out in points 3, 5.2, 5.5.1, 7 and 8 may be fulfilled by his or her authorised representative, on his or her behalf and under his or her responsibility, provided that they are specified in the mandate.
The full entry, with the citation mapping v1 = 02019R1009-20251230, v2 = 02019R1009-20260701, is committed at eu/32019R1009/CHANGELOG.md.